Chris Pucci
Active member
I know this is a truck forum... But dboy was just over and saw the current state of affairs in my kitchen with the super sweet cardboard counter tops and remotely located (in the garage) stove... This is why my truck is parked outside under a tarp...
I thought I would post up pics. Today marked one full month without a complete kitchen - it pretty much sucks. I have almost worked more hours on the kitchen in the last month then I have at work...
Cabinets out and super sweet soffit removed... I hate insulation. And the 4 circuits from the breaker box that 'cut' through the soffit where a nice surprise.
(think enough man hours to build a complete roll cage)
Most of the way through the tear out - 2 layers of linoleum was a bugger... (think enough hours to complete an engine swap)
Half way through the new floor, 3/4" oak kicks butt! (think 203/205 doubler) oh, did I mention I broke my sliding door during the tear out, even though I tarped it off? $$$$ (think cromo front axle shafts)
Last week with most of the cabinet work done - (think fully built th400 trans with all the bells and whistles, installed!) before the island was built:
The stove in on order and should have been here last week (custom seats and belts), the counter top guy just measured today (probably looking at 1350 driveshafts front and rear), but I can't complain - I'm not the one that has been washing dishes in the bathtub! (I did rig up the dishwasher last week....).
I thought I would post up pics. Today marked one full month without a complete kitchen - it pretty much sucks. I have almost worked more hours on the kitchen in the last month then I have at work...
Cabinets out and super sweet soffit removed... I hate insulation. And the 4 circuits from the breaker box that 'cut' through the soffit where a nice surprise.


Most of the way through the tear out - 2 layers of linoleum was a bugger... (think enough hours to complete an engine swap)

Half way through the new floor, 3/4" oak kicks butt! (think 203/205 doubler) oh, did I mention I broke my sliding door during the tear out, even though I tarped it off? $$$$ (think cromo front axle shafts)

Last week with most of the cabinet work done - (think fully built th400 trans with all the bells and whistles, installed!) before the island was built:

The stove in on order and should have been here last week (custom seats and belts), the counter top guy just measured today (probably looking at 1350 driveshafts front and rear), but I can't complain - I'm not the one that has been washing dishes in the bathtub! (I did rig up the dishwasher last week....).
Last edited: