New data I logged

The log is fine but I would like to see the blm table to go with it.
You look like it's still Rich in areas.
 

Attachments

  • 20080229_051446_LOG.xls
    308.5 KB · Views: 435
Yep, way too Rich.
Have you checked the fuel pressure recently?

If the pressure is good and steady then we can look at adjusting the chip and getting you closer.
This log wasn't at atitude was it?
 
Bin is sent.
I pulled a lot of fuel out this time so try to log some data as soon as possible so we can get it a little closer.
 
I would still like to get you off this line of chip and onto a 5.7 based bin.

I just don't like the 7.4 bins.

But if this latest one works fine for you then we can keep going.
It's up to you.
 
Mike,

I burned you a new chip using the new bin from bill . It will in the mail tomorrow.


How/why did it get so Rich? Or was this the 1st time you logged data?
 
ldo_marlin said:
Mike,

I burned you a new chip using the new bin from bill . It will in the mail tomorrow.


How/why did it get so Rich? Or was this the 1st time you logged data?
Click to expand...

It's the first time since the last chip that I could log data. Before I was only able to do it when I hooked up with josh c.
Randy p. Hooked me up with a laptop. So now I can log:winky:
 
I've been following elrod's setup, but did don't know which injectors?

Engine 392 sv
TBI 2"
injectors ?
Fuel pres. 14lbs
ECM 7.4l
 
I am pretty sure Mike's TBI is a Holley 2" base, 80# injectors with a jet performance billet adjustable fuel pressure regulator.
 
I put in the new chip. A little later when I swap the drive slug out on the front( broke a 35 spline hub in hollister and swaped a slug in for temp) I'll take her for a drive and log some data.:icon_smile:
 
You must log in or register to reply here.
Back
Top