MV-446 to 7.3ltr swap

O

Old Codger

New member
HI there. First post for me. Appreciate any guidance.

I have a 2000 F-250 Ford that is rusted beyond reasonable repairs but runs very well. I also have a 1979 S-1924 medium duty International truck with an MV-446 that runs well but really likes (in copious amounts) gasoline. My question is will the flywheel housing bolted to the rear of the MV engine bolt to the rear of the 7.3ltr diesel? The engines, (from outward appearance) look very similar. Really no problem to source a T444E if needed as have one of those located also. The F-250, and IH truck I already have and would like to marry them up if possible.

Thanks,
 
Thanks, from basic measurements they have the same block dimensions but without pulling both engines, I can't tell if they have the mounting bosses, or drill and tapped bosses for mounting the flywheel housings to the back of the block(s).
 
I've read from several sources, and have come to the conclusion, "Maybe". Not real helpful but appreciated all the same. The original MV-446 is destined for a cousin's truck with a knocking MV-404 and if the Power Stroke engine can be used in an air compressor gas to diesel conversion, I will use the flywheel housing from the MV-404 and a new SAE pattern flywheel to couple the air end to the engine.

I started the Power Stroke yesterday after installing batteries and it fired right off after setting several months. It is a good engine I'd really like to make use of in this project though grossly overpowered for the application. The trans/transfer case have a destination and if the "Detroit Locker" rear differential I installed several years ago will fit my 2008 F-350, it too will have a place to go.
 
IIRC, the MV-404 and MV-446 engine architecture was used for the IH 6.9 and 7.3 diesels at the IH Indianapolis Engine Plant.

If you could document the engine mount & flywheel housing adaptor etc. during your work, then everyone will know for sure.
 
You must log in or register to reply here.
Back
Top