DOM Tube Wanted
- Thread starter Mochamike
- Start date
Scooter
Active member
I only have about 5 feet of 2" and about 50 feet of 1-3/4" and about 20 feet of 1-1/2". All .120 wall.
I don't have the bending die for 2" yet. But soon will get it when money aint so funny. If I had the tube and the bending die, I could help ya bend up that 2-1/2".
Only other supplier that I'm aware of is up just past vallejo. Place called team tube.
I don't have the bending die for 2" yet. But soon will get it when money aint so funny. If I had the tube and the bending die, I could help ya bend up that 2-1/2".
Only other supplier that I'm aware of is up just past vallejo. Place called team tube.
Joe M
Member
Speaking of pipe. I was thinking about getting started this winter on my cage. I remember seeing a design where a fella made a piece of plate steel run up the side of the door jam so the pipe doesnt eat up floor space. It was a piece of flat plate that had a pedestal on top that the upper piece joined right at the dash pad height. Anyone remember what company made that design? I have searched my butt off!
Thanks in advance!
Joe m
Thanks in advance!
Joe m
Mochamike
Member
It's very common on jeeps.. Do more searching.
Fyi there is a difference between pipe & tube.
With tube, the thickness of the metal between the id & od is closely monitored/consistent. (picture a circle in a circle, with the inner circle being centered perfectly).
With pipe, the id & od in inches will remain constant but the id circle May drift causing the thickness of the metal to be thicker on one side & thinner on the other.... (picture a circle in a circle, with the inner circle offset a bit).
Fyi there is a difference between pipe & tube.
With tube, the thickness of the metal between the id & od is closely monitored/consistent. (picture a circle in a circle, with the inner circle being centered perfectly).
With pipe, the id & od in inches will remain constant but the id circle May drift causing the thickness of the metal to be thicker on one side & thinner on the other.... (picture a circle in a circle, with the inner circle offset a bit).
Scooter
Active member
Well that was a simple explanation. 
there is one place that I'm aware of, but I won't disclose the info here due to conflicting interest with compition. Although, I don't recall seeing any info if IH Parts America makes and/or sells what you're looking for. As Mike mentioned, a little more resaerch.
there is one place that I'm aware of, but I won't disclose the info here due to conflicting interest with compition. Although, I don't recall seeing any info if IH Parts America makes and/or sells what you're looking for. As Mike mentioned, a little more resaerch.