Latest activity

I did carve out a section to allow clearance for the fan. I also talked with IHPA and told them the aluminum Champion radiator top and...

That section is blocking the core anyway, cut away.

No, you use shims to properly set your pinion angle, prior to setting your caster angle. For example, if you want the pinion pointing...

Ok so you if do , a 6 degree cut and turn then you put a six degree shim in it to make the differential sit flat? Then the C's will sit...

Holley electronic ignition, aka "Gold Box". There should be a Gold Box on your firewall that is the remote ignition unit for this...

Holley electronic ignition, aka "Gold Box". There should be a Gold Box on your firewall that is the remote ignition unit for this...

Is this a Prestolite Ignition or Holley , doing a tune up on this 345 - I know its dusty just want to correct plug wires and cap...

Repaired a rusty spot, wasn't a very large spot but needed to be fixed before it got to be large .. This is behind the fender so...

Repaired a rusty spot, wasn't a very large spot but needed to be fixed before it got to be large .. This is behind the fender so...

That section is blocking the core anyway, cut away.

Repaired a rusty spot, wasn't a very large spot but needed to be fixed before it got to be large .. This is behind the fender so...

That section is blocking the core anyway, cut away.

Because it was! :) I fixed that yesterday. I am not touching the shroud now but still way too close.

Because it was! :) I fixed that yesterday. I am not touching the shroud now but still way too close.

I took the spacer out yesterday to see if maybe I could run the fan without it but the fan would chew into the belts. I lowered the...