Valley Pan for a 345

Scooter

Scooter

Active member
Looking for one in good condition.

While pulling parts for gasket replacement and while cleaning up parts, wondering why there was so much gooey snot on the valley pan, then realized that there was some po virus sneaking around. Needless to say, they had warped and bent it in several areas. And I'm not sure I can straighten it out enough with out using more of that gooey snot on both sides of gasket.
Thanks
 
Awesome. Much appreciate it. Since this is for my 'ole yeller' build, which is the closest rig I have to be driveable soon, I would need to hitch a ride next weekend. Unless you have plans to come down this way anytime soon. Wouldn't want ya to make a special trip just for this.

I'm normally off work, from my full time job, fridays through sundays. For me to arrange to go up there would be during that time frame. I'll let you know when I can set things up

thank you
 
Sent a pm for possibilities of this weekend pickup. That is if I can make the arrangements on my end
 
Thanks again. After several rounds of scheduling a road trip, it was good to finally make it up there and have a good chat with ya. Was cool to check out your Scout. Sound good too. I'll post more into my 'ole yeller' thread when I start piecing things back together

thank you again
 
Thanks again. Got it powder coated and installed. Will be another month or two, maybe sooner depending on my schedule, before I can actually run it. More phics posted in my ole yeller build thread.
20150814_092618.jpg
IMG_20150806_0553011451.jpg
 
You must log in or register to reply here.
Back
Top