S80/800 Bumpers/Sliders/Axles

[Michael Dimock]

All small parts sold!

Front bumper w/ shackle mounts, and was used as an air tank. Slight bow in front push bar tube do to a prius pulling out in front of me. Should bolt to a Scout 80/800. $50
sliders that are 60" long and were welded to my Scout 80 frame. They should also work for an 800 as well. $50
stock rear bumper w/ tubing welded onto bottom and a section cut out. $20
old rear tire carrier. Use it as a starter for you own... $20
all bumpers/sliders are local pickup only.

Located in Grass Valley, CA. All prices are obo. Thanks.

 

[scrub66]

Re: S80/800 and PU Parts

You wouldn't happen to have a carb off the 196 engine you could part with?

 

[Michael Dimock]

Re: S80/800 and PU Parts

Pm sent.

 

[78SSII]

Re: S80/800 and PU Parts

I am interested in the 4 round tail light lens and the amber turn signal lenses. I assume the amber lenses are for a Scout 800? Pm where to send money and I send mailing address.
Thanks.

 

[blhensley]

Re: S80/800 and PU Parts

Im interested in the Scout emblems. I also need payment instructions including shipping.

 

[Michael Dimock]

Re: S80/800 and PU Parts

I am interested in the 4 round tail light lens and the amber turn signal lenses. I assume the amber lenses are for a Scout 800? Pm where to send money and I send mailing address.
Thanks.

Pm sent.

 

[Michael Dimock]

Re: S80/800 and PU Parts

im interested in the Scout emblems. I also need payment instructions including shipping.

Pm sent.

 

[71mtnscout]

Re: S80/800 and PU Parts

Tranny mounts shipped to 92325?

 

[Michael Dimock]

Re: S80/800 and PU Parts

Pm sent.

 

[fredmo1947]

Re: S80/800 and PU Parts

Michael, do you have the little device that plugs into the rear of the gas pedal and has a 90 connecting to the accelerator lever inside the vehicle on an 800. It is a small part only about an inch long and is connected to the lever with a cotter pin?

 

[Michael Dimock]

Re: S80/800 and PU Parts

I'll take a look and see what I can find.

 

[Michael Dimock]

Re: S80/800 and PU Parts

Added today are front and rear Dana 27 axles from my 62 Scout. The front has 11x1 3/4" brakes while the rear has 9x2" with both having 4.27 gears. There is a powerlock in the rear and both axles were painted and brakes gone through 4 years ago when I was using them in my Scout. $200 for the pair or make me an offer. These are located at my parents house in alsea, or.