RPT Stainless Steel Guage Overlay

7

78SSII

Member
Hello Jeff,

I have a couple questions on the rpt stainless steel gauge overlay. Is it possible to get it with no cut outs at all? And also, someone on the bb mentioned it comes with side additions. What are these side additions as I don't see them in the picture? Do they cover the side of the green main dash part or something?

Thank you,
bill
 
Sorry, but we don't offer any panels without any cutouts - only with or without a radio cutout. Stainless steel is very hard to cut/drill holes into hence why these are laser cut.

The side pieces you speak of are to cover the gap that shows on the sides of the panel when the panel is installed(make sense?). The attached pictures show them installed(little triangle pieces).

attachment.php


attachment.php


Let me know if you have any other questions.
 

Attachments

  • gauge panel 1.jpg
    gauge panel 1.jpg
    51.7 KB · Views: 529
  • 240-4002_IMG.JPG
    240-4002_IMG.JPG
    30 KB · Views: 511
Those fill in pieces look great and understand them now.

If and when I get to the point of installing the gauge I want, would I be able to send you the measurement and or the gauge and have you cut the hole in it for me?

Thank you
bill
 
If we made these in house then we could cut you out the holes per your specification but these are made for us from an outside source. It can be done but there May be an additional setup charge. I'll check into it for you and post back up when I have an answer for you.
 
Jeff I bought 2 1/16 gauges not realizing your panel is for the bigger 2 5/8 gauges, have you seen a bezel that could be used to use the smaller gauges? Or get the panel with 2 1/16 holes

thanks
 
You must log in or register to reply here.
Back
Top