Jeff -
the blower motor I purchased from you, like the one from napa, is a little too tall. When I transfer the blower wheel from the old motor to the new one it bottoms out on the case. If I screwed it down the wheel would be unable to turn.
I suppose I could grind the flats on the shaft down a quarter of an inch further, but I'm hoping for a better answer. Here's a link to the original discussion: http://www.forums.IHPartsAmerica.co...eater-parts-blower-motor-valve.html#post51415
Suggestions?
--jim
the blower motor I purchased from you, like the one from napa, is a little too tall. When I transfer the blower wheel from the old motor to the new one it bottoms out on the case. If I screwed it down the wheel would be unable to turn.
I suppose I could grind the flats on the shaft down a quarter of an inch further, but I'm hoping for a better answer. Here's a link to the original discussion: http://www.forums.IHPartsAmerica.co...eater-parts-blower-motor-valve.html#post51415
Suggestions?
--jim