driveshaft slip yoke and spline

JAYSON

JAYSON

Member
Im looking to replace my driveshaft spline and yoke what doner trucks have the same u-joint size 1310 I belive?
 
A driveline slip yoke system is a matched set with male and female components. That are properly phased and then the entire driveline balanced. Why not have the driveline serviced with a new system, that is a safety issue.

Many vehicle drivelines use that same slip yoke system.
 
Most older 1/2 ton and smaller trucks/jeeps/etc use 1310 sized driveline parts. 3/4 ton stuff uses any thing from 1310, 1330 (Ford) or 1350 -- so be very careful if you are pulling from 3/4 ton stuff - they look real close but are not...

But it isn't as easy as mixing and matching used stuff unless you swap the entire driveshaft for another driveshaft.

If my driveline splined section was worn/bad/etc, I'd just replace the whole thing with new or have the exisiting one rebuilt by a professional.

Now if we are talking offroad wheeler only - I'd build my own with square tube!
 
Thanks 4 the fast response as always. I talked to the driveshaft place he said basicly the same thing and can cut it down if needed
 
You must log in or register to reply here.
Back
Top