Bolts to hold Transmission

[78SSII]

Hello all,

I have a slight problem. I was going to install my new transmission mount (t-19 transmission), but when I crawled underneath I found that I didn't have either threaded mounting stud!

What is the length and thread of the studs so I can go get some to replace the ones that are missing?

Thanks all.
Bill

 

[Michael Mayben]

The sii parts list is somewhat ambiguous regarding the fastener callouts for the various rear engine/transmission support hardware. It omits the reference number/location and shows two variations of the parts in question.

The actual sii transmissions I have here all use a 7/6"-14tpi (coarse) mounting thread. However, some May also use a 3/8"-16tpi (coarse) thread. The length callout is also not defined in all cases, but you should easily be able to figure that out...I'd say it's a nominal 2-1/2" length.