11” Angle Link to 12” Borg and Beck clutch

72Travelex

72Travelex

New member
So it turns out my Travelall all had an 11” angle link clutch in it and I have a new 12 inch Borg and back and I’m wondering what else I need to get the 12 inch clutch to work because the throwout does not look like it will interchange. Any help would be appreciated.
 

Attachments

  • IMG_3939.jpeg
    IMG_3939.jpeg
    2.4 MB · Views: 8
  • IMG_3940.jpeg
    IMG_3940.jpeg
    2.6 MB · Views: 5
  • IMG_3941.jpeg
    IMG_3941.jpeg
    3.6 MB · Views: 5
That looks like a short collar throw out, is that what was with the old clutch or the new?

There is also a long collar throw out bearing

They physically fit in the exact same spot.
 
The new clutch, I just got from IHPA and the bearing in there is by itself. It has no collar.
 
Last edited:
Well you will have to put that collar on that input shaft and test fit if it has enough throw for that clutch. Otherwise you will need a long collar one.
 
What is the difference in height between the long collar and the short collar? I ask because currently the difference in height of the release arms is about a half inch and that is with the retaining bolts still in the 12 inch clutch. The part I bought is CLUTCH-KIT-12-BB-NEW if that helps
 
You must log in or register to reply here.
Back
Top