Spindle seals

P

paul_is_scouting

New member
So I just finished re-gearing my front end and cannot find one of my inner spindle seals. I know the kits are available because I just did them. Does anyone have a napa or carquest part number for one of these so I don't have to buy another kit?
 
paul_is_scouting said:
so I just finished re-gearing my front end and cannot find one of my inner spindle seals. I know the kits are available because I just did them. Does anyone have a napa or carquest part number for one of these so I don't have to buy another kit?
Click to expand...

What truck? What axle? What year?

Ron
 
These are napa numbers,
inner nos 22311
outer, nos 711818
you can go to napaonline and it shows the measurements
they don't actually list a traveler

I am sure Jeff here at ihon can fix you up also.

Ron
 
I called them this morning and you are right about them not having it listed. They did ask if it was xlc which made me feel like I was going to get lucky for a min. I have one with me and will stop by there on the way home today to see if they match to you rnumbers. Thanks for the info!
 
Unfortunately those numbers did not cross to what I have.
The inner seal number was similar but about 2 times larger than
the one I am looking for.
 
Well I am sorry I was no help it would not be the first time napa was misguided. Lol
I keep looking, it's funny they should be the same for scoutii and travellers, but I am more familiar with early 70's scouts.

Call Jeff
ron
 
Yeah that is the one.. I have new v seals and am missing the smaller seal that fits inside the spindle next to the end of the bearing.
If you could also tell me where that thrust washer is supposed to go because I don't remember it when I tore these down a couple years ago when I started this part of the project? I can't find a nice breakdown in the book either.

78 traveler Dana 44 w/discs and lock-o-matics
 
The v seal goes around the outside of the thrust washer and the washer also pushes against the smaller seal to keep it pressed up against the end of the needle bearing.
 
I hate incompetent, ignorant and lazy people. I have been dealing with napa more recently because recently they have had much better counter help, but even they couldn't come up with anything on these. I went into carquest Friday and the counter person could not find a listing in the computer and ordered some out of the "by application seal book". I go in today to get them and they could not be more wrong. Needless to say a different counter person who is helping me today goes straight to the shelf and picks up two of the correct seals. Weekend wasted waiting on seals that I could have had on Friday...the story of my life.
 
Oh yeah...just for reference the carquest part number for these is #722108 they are specifically for the Dana/spicer 44 - 4wheel drive - front inner hub spindle seals. $2 and some change each.
 
You must log in or register to reply here.
Back
Top