Bearing trouble

P

pineneedle

Member
I bought a Dana 20 rebuild kit from a transfer case parts vendor. Unfortunately, the kit contained the wrong bearings for the front drive output shaft. I can wait until Monday and get them from the vendor, but that will take many days, and I am tryng to finish this rebuild up. Can anyone tell me what the timken bearing cup and cone part numbers are? If I can get these numbers, I might be able to access the bearings locally tomorrow. Again, the bearings in question are the two that fit on the ends of the front drive output shaft of a Dana 20. If you are wondering why I don't use the numbers off the old ones, it is because I threw them out last week, thinkng I would no longer need them. Thanks in advance. Pineneedle
 
What bearing do you have now? Front output bearing mixups happen a lot since most don't know that when Dana went from coarse spline outputs to fine spline the bearing on the front output changed(the cones are the same).
 
Thanks for the reply. The bearings supplied with the novak kit are koyo. The race is #14276, and the bearing itself is #14116. The bore of the bearing is way to small for the output shaft. Thanks, pineneedle
 
You must log in or register to reply here.
Back
Top