• To ALL forum users - As of late I have been getting quite a few private messages with questions about build ups here on the forum, or tech questions about your personal project. While I appreciate the interest, sending me a private message about these topics distracts from, and undermines the purpose of having a forum here. During the day I wear many hats as a small business owner-operator and I work tirelessly to provide the absolute best service possible to you, our valued customer. When I created this forum I rounded up some of the best minds I knew so that any tech question you might have could be asked and answered by either myself or one of my highly experienced moderators, this way the next time this same question is asked the answer can be easily found and utilized by the next IH enthusiast having the same question. This allows me the freedom to run the day to day operations of the business and minimize the impact to shipments and shop activities that these distractions can cause. It is of the up most importance for me to complete the daily tasks in order to best take care of you our customer, all the while providing you a forum to get the level advice and input you have come to expect and deserve from the premier IH shop in the country.

    So with that I ask that anyone with a question about one of our build ups or a general tech question to please use the forum as it was intended. I am absolutely available by telephone to answer your questions as well but at times may direct you back to our website to better field your question or questions. Most other private messages I will be glad to answer for you.

    Thank you for your understanding.

    Jeff Ismail
    Owner/Operator

66 Travelall 4x4 Rust Under Dash Corners

pplaut

Member
I just called IH Parts America to see if they had any replacement patch panels for the corners driver and passenger side where the heater vent (passenger) fresh air vent (driver) come in from the cowl.
They don't have anything. I am wondering if anyone here has made a patch panel, or has a template I could use? I'm also going to think about proper drainage. :)

I appreciate any and all feedback. :)

Thanks!
~P.
 

darren y

Member
Where are you located? I might have a source for a couple parts cabs, that the metal could be sourced from. I'm in Sparks, NV 89436.
 
Top