nogomofo
Member
I picked up this little 800 with the intentions of throwing some paint on it and wheeling it as is. Well that plan has changed!
I picked up a full width (67"wms) Dana front and 14 bolt rear and plan to run 39.5" iroks.
My question is about leaf spings and keeping the rig low..ish.
I want to find a set of staggered pin springs so I can get the front axle closer to the fangs and the rear a bit farther back as well.
Has anyone used 52" dakota springs on all four corners ? What would be a good setup.
It still has a 304 up front but I May switch to a sbc/400 setup.
It's been a while, I'm glad to be back !