1961 SCOUT 80 / WHEELER / $4000 / SAN JOSE / 345 / T19 / DANA 300

S

scoutdude80

Moderator
1961 Scout 80
$4,000
san jose

old school wheeler
needs some maintenance and tlc.

345
headers
t-19 wide with grannylow
12” hyd IH truck clutch
Dana 300
custom cv driveshafts f& r
full float Dana 60 w power lock 4:10 cear / full width
Dana 44 w power lock /full width
35 x 16.5
3 tanks 40 gal capacity
dual battery
warn 9000 lb winch
custom push bar front
custom tire rack back [it was the prototype for damien at d&c]
Full cage / seats attached
painless wiring installed
custom interior

much more in parts
misc engine parts including extra carbs
2 chrome valve covers
flywheel & clutch assembly
seats
and a lot more. It all goes with the truck


I’m listing this for bill. Pm or email me for more info

1 right front.jpg

2 right rear.jpg

3 front.jpg

4 leftfront.jpg

5 leftrear.jpg

6 engine.jpg

The ksjo sticker still looks fresh
7 inside.jpg
 
How does it run and drive? Any real significant issues or just general maintenance and minor repairs?
 
Ok I sold the 4runner I have 2 grand right now I just need to sell my 73 Scout and I will have another 2 grand hope its not sold by than
 
Nice looking Scout, I have a few questions, you saw it is a 61, but you have a later 800 nose clip and dash?
The roll cage, was this built by the owner or bought, if you take the metal mesh of the top, will a hard top fit?
Do you have any video of your Scout on the trail?

Thanks
martin
 
There is no top and one would not fit over the cage.
Bill doesn't have the doors, but a set could be installed.

Chris / pm sent
 
Bill made the cage when he worked at anything Scout and all scouts plus. Pm me your phone number and I will put you in contact with him. No vids

this pic is from the western regionals years ago.
bill's 80.jpg
 
It’s only listed here.
Basically, bill is in no hurry to sell it. If it sells – fine. If it doesn’t sell – fine.

He has be doing some maintenance on it lately.
 
You must log in or register to reply here.
Back
Top