1310 Ujoint-26 spline-CV yoke

DC67 800

DC67 800

Member
Hey Jeff,
a while back I bought the 1310 ujoint-26 spline-cv yoke from you for my Dana 300.

I noticed that the u bolts from the standard 1310 yokes do not fit the cv yokes as the spacing on its bolt holes is slightly wider. Is there a special u bolt that is required for this yoke? Don't see anything on the website.

Thanks,
damian
 
A cv yoke is to be used with a cv joint with bolts going thru the yoke into the cv joint. Yes you can use ubolts with this yoke if you're not running a cv joint but as you found out they need to be slightly wider. I do know a part number for a wider Ubolt but would suspect one for a 1330 ujoint May fit the yoke.
 
You must log in or register to reply here.
Back
Top