Replacing ignition lock cylinder

Danny Phillips · 03-01-2010, 09:53 PM

I just bought a lock set for my new to me 74 Scout II. Doors and liftgate were easy. How do I change out the ignition lock cylinder thanks, Jeff for the prompt delivery of the lock set.

Mark Ashford · 03-01-2010, 10:34 PM

Here's a pictorial I made a few years back for a non-tilt column. Never got around to converting it to a full write-up, but it should help.

If your confused about a step, post up the picture and ask.

Mark's photo galleries :: ignition replacement

Danny Phillips · 03-01-2010, 11:07 PM

Thanks Mark; I wasn't sure if I had to remove the steering wheel. I'm planning on installing an aftermarket sw this summer so that will be a good time to swap switch locks and lube the turn signal cams, Danny

Yellowscout74 · 10-06-2018, 06:19 AM

Hi Mark.

Do you still have the photos on changing out the ignition lock? The pictures are not there any longer. I know it's been a while for this post but trying to do this today.

Thanks a lot

03-01-2010, 09:53 PM	#1
Danny Phillips Senior Member Join Date: Feb 2010 Member Number: 1682 Location: Kelseyville, CA Posts: 214	Replacing ignition lock cylinder I just bought a lock set for my new to me 74 Scout II. Doors and liftgate were easy. How do I change out the ignition lock cylinder thanks, Jeff for the prompt delivery of the lock set. __________________ 2015 RAM 2500 Heavy Duty Crew Cab Long Bed Laramie Diesel, 2002 Wildwood 30 ft Fifth Wheel, 1974 Scout II, 345, 727, Dana 20, Dana 30 front w/discs and Dana 44 rear.

03-01-2010, 10:34 PM	#2
Mark Ashford Senior Member Join Date: May 2009 Member Number: 1099 Location: Seattle Area, WA Posts: 272	Re: Replacing ignition lock cylinder Here's a pictorial I made a few years back for a non-tilt column. Never got around to converting it to a full write-up, but it should help. If your confused about a step, post up the picture and ask. Mark's photo galleries :: ignition replacement

03-01-2010, 11:07 PM	#3
Danny Phillips Senior Member Join Date: Feb 2010 Member Number: 1682 Location: Kelseyville, CA Posts: 214	Re: Replacing ignition lock cylinder Thanks Mark; I wasn't sure if I had to remove the steering wheel. I'm planning on installing an aftermarket sw this summer so that will be a good time to swap switch locks and lube the turn signal cams, Danny __________________ 2015 RAM 2500 Heavy Duty Crew Cab Long Bed Laramie Diesel, 2002 Wildwood 30 ft Fifth Wheel, 1974 Scout II, 345, 727, Dana 20, Dana 30 front w/discs and Dana 44 rear.

10-06-2018, 06:19 AM	#4
Yellowscout74 Junior Member Join Date: Aug 2018 Member Number: 9372 Location: Seattle Posts: 17	Re: Replacing ignition lock cylinder Hi Mark. Do you still have the photos on changing out the ignition lock? The pictures are not there any longer. I know it's been a while for this post but trying to do this today. Thanks a lot

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode