IH PARTS AMERICA
Click Here!

Go Back   IH PARTS AMERICA > Tech Forums > Carb Tech
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read Photo Gallery IH Store Home

Reply
 
Thread Tools Display Modes
Old 08-17-2019, 07:19 AM   #1
Dearoldad
Junior Member
 
Join Date: Aug 2019
Member Number: 9779
Location: Alberta, Canada
Posts: 4
Default 1967 International SV345 Electric Choke Wiring

Hello, just joined this forum. Recently purchased a 1967 bus conversion (Loadstar 1600) with a 345. One of the PO's has totally mangled the wiring, and that is not my strong suit. There is no wire connected to the electric choke (single terminal), and I'm wondering what it should be connected to. Some forums say it should be connected to a relay off an oil pressure sensor, and some say just right off the ignition. Sorry, I don't have a pic to post today.
Dearoldad is offline   Reply With Quote
Old 08-17-2019, 08:00 AM   #2
Robert Kenney
Super Moderator
 
Robert Kenney's Avatar
 
Join Date: Aug 2008
Member Number: 543
Location: So Cal
Posts: 3,417
Default Re: 1967 International SV345 Electric Choke Wiring

Connect it to ignition switch switched power supplied in the run position only. Do not connect it to the ignition coil + terminal wire. That circuit most likely has a resistance wire of ballast resistor in it. You can connect to the ignition switch side of that circuit.
__________________
Robert Kenney

“Don't lift until the fear of death over comes the fear of speed.” Author Unknown
Robert Kenney is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -8. The time now is 06:30 PM.