IH PARTS AMERICA
Click Here!

Go Back   IH PARTS AMERICA > Tech Forums > Axle Tech Questions
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read Photo Gallery IH Store Home

Reply
 
Thread Tools Display Modes
Old 08-02-2019, 02:18 PM   #1
SSMinnow
Junior Member
 
SSMinnow's Avatar
 
Join Date: May 2007
Member Number: 226
Posts: 22
Default Wheel stud.

It’s been years since I replace my rotors. When I did I had the studs pressed in. Now my studs are loose and fall out. They will torque down just fine, but when I install the wheel I have to start them by hand and pull them so they won’t just rotate.

I have read that maybe a bigger spline. But all the counter guys does is look at me and ask what year.

Can anyone give me a good part number to a wheel stud that will fit?
SSMinnow is offline   Reply With Quote
Old 08-03-2019, 03:24 PM   #2
Robert Kenney
Super Moderator
 
Robert Kenney's Avatar
 
Join Date: Aug 2008
Member Number: 543
Location: So Cal
Posts: 3,408
Default Re: Wheel stud.

Have you verified the hole sizes you are pressing the studs into? I assume the studs are ribbed where they press into the hub.
These are usually defined by the hole and such. Dorman has a nice web sight and you can review all of the other studs that are in the range of yours.

When you remove one of the loose studs, have a look at the grooves the stud made in the hole. They should displace material as the stud goes in and that fills the groove between the ribs on the stud. Basically you end up with a fit that requires a heavy hammer to budge if at all.

If that fails to give you joy, Loctite has a locking compound for studs that will stop the movement.
__________________
Robert Kenney

“Don't lift until the fear of death over comes the fear of speed.” Author Unknown
Robert Kenney is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -8. The time now is 04:14 PM.