View Single Post
Old 12-06-2012, 06:24 AM   #95
snoman
Junior Member
 
Join Date: Nov 2012
Member Number: 5225
Location: Minnesota
Posts: 11
Question Re: I-4 and SV Engine Non-Oiling Rocker Assembly

Ok so I went through the old iron part 1 deal. Spun the oil pump with a shaft I made. It didn’t take too long and lots of oil was coming out the drivers side rocker shaft. Turned motor over by hand a little bit spun it again this time lots of oil on the passenger side. Here is the question: if I am getting good flow up that high shouldn’t my in dash oil pressure gage go up? Because it did not. And I think it should have. Do I need the battery hooked up isn’t the gage electronic? Is my gage bad? I don’t have a pressure tester. What is my problem

thanks
__________________
1970 Scout 800 304ci 4 speed man 4x4 “class project”
snoman is offline   Reply With Quote