View Single Post
Old 06-12-2010, 05:08 PM   #84
Robert Kenney
IHPA Tech Moderator
Robert Kenney's Avatar
Join Date: Aug 2008
Member Number: 543
Location: So Cal
Age: 49
Posts: 3,319
Default Re: Before and After of My Scout 80 CS

I have the knuckles back on and back plates cleaned up. I had to replace one brass cone because the spline was loose. At least I had some. Tomorrow I fill finish assembling it and start building the new tierod parts. I am machining the draglink attach point out of 1075 steel and threading the tierod end for the right side into it. That should allow for the longest possible drag link and best motion.
Robert Kenney

“Don't lift until the fear of death over comes the fear of speed.” Author Unknown

Last edited by Robert Kenney; 06-16-2010 at 05:54 PM..
Robert Kenney is offline   Reply With Quote