View Single Post
Old 10-07-2019, 02:56 PM   #1
mbiver
Member
 
Join Date: Aug 2018
Member Number: 9359
Posts: 38
Default Installing Holley 2300

Just got the new Holley 2300 P/N 0-7448 kit from IH Parts and had a couple installation questions. The kit came with the thick mounting gasket, and also a thin gasket (picture attached). Iím only supposed to use the thick gasket, correct? The thin one is just extra? Also, regarding the gold mounting studs, do I just finger tighten them to start and then the hold down nut fully tightens them when torqued? Thanks.
Attached Images
File Type: jpg B5F2518E-ACC0-4F0E-B577-0891A19EA9ED.jpg (69.1 KB, 34 views)
File Type: jpg 5BB1C7D3-5941-412C-92AC-D875BE3B76F4.jpg (68.6 KB, 39 views)
__________________
1978 Scout II with 1977 345 engine
Four wheel drive Dana 44 Axle's, Dana 20 T-Case, Power Steering, Power Brakes (Disc/Drum), no A/C.
Manual trans, Borg Warner 3-speed w/floor shift.
Prestolite distributor with petronix.
Fuel System: New 19Gal. Poly tank/Sending unit and Holley 2300 P/N 07448 kit from IHPartsAmerica, Nylon fuel line, relined original fuel neck filler tube.
Unknown non-oem modifications
mbiver is offline   Reply With Quote