View Single Post
Old 12-30-2008, 07:50 AM   #26
Robert Kenney
IHPA Tech Moderator
 
Robert Kenney's Avatar
 
Join Date: Aug 2008
Member Number: 543
Location: So Cal
Age: 49
Posts: 3,315
Default Re: Before and After of My Scout 80 CS

Greg,
you posted again while I was typing and dealing with employees.

When you torque the hub on to the taper is the nut or washer bottoming on the end of the shaft taper? Take the nut off and look. You May not be generating enough clamping force. If you think that is a possibility add a washer so the hub has the ability to be forced on the taper unimpeded.

I have two hubs that were enlarged so the nut would bottom before reaching enough clamping load.
__________________
Robert Kenney

“Don't lift until the fear of death over comes the fear of speed.” Author Unknown
Robert Kenney is offline   Reply With Quote