IH PARTS AMERICA
Click Here!

Go Back   IH PARTS AMERICA > Search Forums
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read Photo Gallery IH Store Home

Showing results 1 to 25 of 242
Search took 0.01 seconds.
Search: Posts Made By: Richard
Forum: Fabrication 11-28-2019, 03:34 PM
Replies: 1
Views: 161
Posted By Richard
Front Bucket Seats

I know this topic has had some mileage on it, but was looking to see if there are any updated comments.

I have a 77 SII, 196, T-19, D20, D44 front and back, 2 " lift and 31's. Basically stock....
Forum: Suspension Tech 11-28-2019, 03:27 PM
Replies: 2
Views: 204
Posted By Richard
Scout II Suspension

looking for me some suggestions:
I have a 77 SII, 196 1bbl, T-19, D20, D44 front and back. Basically a stock Scout. Looking for some suggestions re:

a spring lift 4", but with a "soft" ride. I...
Forum: Electrical Tech 09-04-2019, 07:46 PM
Replies: 3
Views: 474
Posted By Richard
CRV's

is there a way to test these CRV's before installing them?

Thanks,
Forum: Basic Tech Questions 08-25-2019, 10:11 AM
Replies: 3
Views: 417
Posted By Richard
Re: Cruise Control unit

Perfect Circle is out of business and the company that bought them out does not list any assistance for rebuilding units, only new units.
Forum: Basic Tech Questions 08-25-2019, 10:10 AM
Replies: 3
Views: 417
Posted By Richard
Re: Cruise Control unit

for further information I have attached a couple of snapshots of the unit.
Forum: Basic Tech Questions 08-24-2019, 06:33 AM
Replies: 3
Views: 417
Posted By Richard
Thumbs up Cruise Control unit

hello there all!

I have 3 Cruise Control units for Scouts. The have been sitting for years on my shelf, so I thought it would be good time to maybe rebuild one of them for my 79 Traveler. The 79...
Forum: Basic Tech Questions 08-19-2019, 04:58 PM
Replies: 0
Views: 290
Posted By Richard
Vacuum Valve Solenoid

Please see picture attached. It goes on the firewall of my 79 Traveler. It is my restoration: 79 Traveler, 345, 4bbl TQ,p/s,p/b,a/c,tilt, cruise, D44 front and back.

The vacuum diagram shows...
Forum: Carb Tech 08-18-2019, 05:56 AM
Replies: 18
Views: 1,015
Posted By Richard
Re: for my california brethren, failed a smog and now a gross polluter

Quick thought:

I thought that in this state, California, that you could not adjust your timing by more than 3 degrees. I've seen the smog manuals for Scouts ( I have a 77 SII with a 4 cyl,1 bbl,...
Forum: IH Parts America Product Questions 08-05-2019, 04:22 PM
Replies: 2
Views: 575
Posted By Richard
Re: Need Engine Decal!

thank you for the quick response, it is appreciated. Yes, i just ordered the decal from Scoutco. Again, thank you.

Richard
Forum: IH Parts America Product Questions 08-04-2019, 07:23 AM
Replies: 2
Views: 575
Posted By Richard
Need Engine Decal!

Good day to you!

I have a 79 Traveler - 345, 4bbl TQ, Auto, p/s, p/b, a/c, tilt, cruise, D44 front and back. Basically stock. I am restoring my Traveler and have found all engine decals except...
Forum: Carb Tech 08-03-2019, 06:51 PM
Replies: 116
Views: 68,251
Posted By Richard
Re: Carter Thermoquad "Spreadbore" Stuff

all:

I appreciate the quick response. i did buy a carb kit fro IH parts America last year (planning on this project). I took the TQ this week to a carb guy i've known for a few years. He...
Forum: Carb Tech 07-31-2019, 04:39 PM
Replies: 116
Views: 68,251
Posted By Richard
Re: Carter Thermoquad "Spreadbore" Stuff

Hope this thread is still going:

I have a 79 Traveler, 345, 4bbl, TF Trans, D44 front and back, a/c, tilt, cruise, p/b - the basics.

I am in the process of restoring this beauty, and it's...
Forum: Transfer Case Tech 07-11-2019, 06:35 AM
Replies: 31
Views: 9,042
Posted By Richard
Re: speedo gears???????

well, well, well!!!!!!

for a minute, I thought I was going crazy! HAH!
Forum: Gas Engine Tech 06-30-2019, 08:14 AM
Replies: 1
Views: 348
Posted By Richard
1979 345 Engine Build

1979 Traveler, Carter Thermoquad, 727TF, PS, PB, A/C, Tilt, Cruise, D44 front and back, Detroit TrueTracs front and back.

After a lot of years, I am spending this summer putting everything back...
Forum: Transmission Tech 06-05-2019, 08:11 PM
Replies: 55
Views: 24,269
Posted By Richard
Re: Proper Clutch Identification

Appreciate the quick reply. Will resolve this weekend.

Thanks,
Forum: Transmission Tech 06-03-2019, 11:18 AM
Replies: 55
Views: 24,269
Posted By Richard
Re: Proper Clutch Identification

This might be a bit off subject, I think:

trying to determine how to "adjust" the clutch pedal play. I have about an inch and a half of play on my clutch pedal (clutch pedal fully free and I can...
Forum: Electrical Tech 03-21-2019, 03:35 PM
Replies: 6
Views: 2,126
Posted By Richard
Re: El Cheapo Brighter Headlights

ok, so:

the wires that actually plug into the back of the headlight (the low beam and high beam wires) , you pulled them, plugged them into the relay, and then from the relay you used 10 ga. wire...
Forum: Electrical Tech 03-19-2019, 04:39 PM
Replies: 6
Views: 2,126
Posted By Richard
Re: El Cheapo Brighter Headlights

thanks for the reply, and would you mind sharing a few pix of the setup? I am more of a visual learner and a picture is worth a 100 words. Thanks.

Richard
Forum: Electrical Tech 03-18-2019, 05:56 PM
Replies: 6
Views: 2,126
Posted By Richard
Re: El Cheapo Brighter Headlights

hey there!
liked your post. Need some info: where are you "splicing" in the relays? at the firewall? after the bulkhead connector? can you post some pics?

I have a 77 SII and have the "dim"...
Forum: Electrical Tech 02-26-2019, 10:39 AM
Replies: 0
Views: 388
Posted By Richard
ignition coil for 4 cyl vs, 8 cyl.

77 SII, 196 1bbl, 4sp, D20, D44's,stock.

Question: does the 4cyl take the same ignition coil as the 8 cyl? or is there a difference (i.e. resistance?)

Please and thanks.
Forum: Transfer Case Tech 02-26-2019, 05:52 AM
Replies: 31
Views: 9,042
Posted By Richard
Re: speedo gears???????

Thanks all for the info. Well, what I did not notice is that the speedo is working (the trip meter), only in reverse. The numbers are getting smaller. I did not check the 3 speed when I had it (n...
Forum: Ignition Tech 02-18-2019, 07:17 AM
Replies: 1
Views: 573
Posted By Richard
Re: Distributor internal weights/spring tension

while I am at it:

would like to replace the original coil.

1. is the stock coil the same for 4 cyl or 8 cyl?
2. and/or what is the difference?

I do realize that these engines do not...
Forum: Ignition Tech 02-18-2019, 07:09 AM
Replies: 1
Views: 573
Posted By Richard
Distributor internal weights/spring tension

1977 SII, 4cyl, 1bbl Holley, 4 spd T-19, D20 tc, D44 front and back. Original Holley Disto with a Pertronix module installed. BASIC.

The Scout runs fine, just looking to tweak maybe some...
Forum: Transfer Case Tech 02-15-2019, 08:10 PM
Replies: 31
Views: 9,042
Posted By Richard
Re: speedo gears???????

ahhhhhhh...............................
the D20 TC little doo-hickey screwed into the side of the TC is turning CW. crapola! there are no kinks in the cable. wht do I do? :icon_eek:
Forum: Transfer Case Tech 02-15-2019, 10:28 AM
Replies: 31
Views: 9,042
Posted By Richard
Question Re: speedo gears???????

Well, I have another issue with my TC and speedo cable. I have a 77 SII. 196, 4spd with D20 TC. I swapped out the original 3 spd and chain drive TC for the 4spd and D20. My issue is this: the...
Showing results 1 to 25 of 242

 

All times are GMT -8. The time now is 06:30 AM.