IH PARTS AMERICA
Click Here!

Go Back   IH PARTS AMERICA > Search Forums
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read Photo Gallery IH Store Home

Showing results 1 to 25 of 33
Search took 0.00 seconds.
Search: Posts Made By: BrokeGunner
Forum: Electrical Tech 10-10-2018, 10:33 AM
Replies: 27
Views: 907
Posted By BrokeGunner
Re: 1976 Scout Starting Problems

My experience with Scouts is all with the 80/800 series, but assuming the bulkhead connectors are similar... I have been through this multiple times on multiple vehicles.

I have had good results...
Forum: Axle Tech Questions 10-09-2018, 01:13 PM
Replies: 1
Views: 177
Posted By BrokeGunner
Advice on axle/disc brake upgrades

I'm getting the bugs worked out on my 800B and starting to drive it more (finally!!) and I am quickly realizing the brakes and steering are not up to par. I have a 30 in the front and a flanged axle...
Forum: IH Parts America Product Questions 10-01-2018, 07:14 AM
Replies: 2
Views: 273
Posted By BrokeGunner
Re: Door glass plastic guide track install?

Hi Jeff,

I did see the adjustment on the bottom of the door but I couldn't figure out what it does. So I am assuming that it adjusts the angle of the lower portion of the front track?

Is it...
Forum: IH Parts America Product Questions 09-30-2018, 12:19 PM
Replies: 2
Views: 273
Posted By BrokeGunner
Door glass plastic guide track install?

Im finally getting around to installing the plastic track that goes into the front edge of the door glass on an 800B.

I took the door all apart and removed the vent window assembly, then cleaned...
Forum: IH Parts America Product Questions 04-17-2018, 10:03 PM
Replies: 3
Views: 970
Posted By BrokeGunner
Re: Reverse shackle bushing/spring eye questions

Jeff, i appreciate the help, i got all the parts now and i am now trying to figure out where to put everything ;)

Can you give me specific instructions on what washers go where? I currently have...
Forum: Reader's Ride's 04-03-2018, 10:47 AM
Replies: 16
Views: 4,466
Posted By BrokeGunner
Re: Parked in a field for 30+ years, 68 Scout rescue and rehab

The friend that was helping me with the fence has a gas powered one as well, but it was not running very well so we were forced to haul that big compressor up to the top of the hill and drag air...
Forum: Reader's Ride's 04-02-2018, 09:12 PM
Replies: 16
Views: 4,466
Posted By BrokeGunner
Re: Parked in a field for 30+ years, 68 Scout rescue and rehab

I haven't done much work to this old scout lately, but I have gotten plenty of work OUT of it!! I have been fencing off our 2.2 acres of property and it is quite a chore with this steep hill behind...
Forum: Gas Engine Tech 04-02-2018, 09:00 PM
Replies: 3
Views: 840
Posted By BrokeGunner
Re: Q: regarding fuel pump choices on 800B 304

Well I went back on Ebay and made a deal on the pump I saw posted there. I received the box a few days ago and to my surprise it held 2 brand new Airtex 1117 pumps in the original boxes!! It took...
Forum: Basic Tech Questions 04-02-2018, 08:54 PM
Replies: 4
Views: 681
Posted By BrokeGunner
Cool Re: Comanche sliding window rubber source?

I still haven't received the samples from Steele rubber so I decided to take a road trip with the Comanche and drive to Stockton Auto Glass in Lodi, Ca. My buddy and I made it down there with no...
Forum: IH Parts America Product Questions 04-02-2018, 05:17 PM
Replies: 3
Views: 970
Posted By BrokeGunner
Question Reverse shackle bushing/spring eye questions

Hey guys,

I did my reverse shackle last week and all went well until i went to install the springs into the new front spring hangers and had a half inch of extra space. I called the shop last...
Forum: Basic Tech Questions 03-24-2018, 10:53 AM
Replies: 7
Views: 800
Posted By BrokeGunner
Re: Universal joint problems - rear drive shaft.

I tried to add photos from my phone but I couldn't get it figured out. I will see if I can mail them to my work pc and post them this evening.
Forum: Basic Tech Questions 03-24-2018, 07:17 AM
Replies: 7
Views: 800
Posted By BrokeGunner
Re: Universal joint problems - rear drive shaft.

Well if that's the case that all scout u-joints are external snap ring, that would mean someone swapped my driveshaft for one with internal rings.

I guess I'll have to order a new one. Thanks...
Forum: Basic Tech Questions 03-23-2018, 09:55 PM
Replies: 7
Views: 800
Posted By BrokeGunner
Universal joint problems - rear drive shaft.

Last week i noticed a puddle of oil under the pinion on my 1971 800B Dana 44. I went to check the seal and found the pinion nut loose so I pulled it all apart to make sure the bearings were good. ...
Forum: Gas Engine Tech 03-22-2018, 11:04 AM
Replies: 3
Views: 840
Posted By BrokeGunner
Q: regarding fuel pump choices on 800B 304

Hey Guys, I am trying to confirm my decision to go with a non-vacuum fuel pump on my '71 800B w/304.

The PO installed a cheap electric pump next to the passenger motor mount so I currently have no...
Forum: Axle Tech Questions 03-21-2018, 09:00 AM
Replies: 6
Views: 958
Posted By BrokeGunner
Re: Rebuild?

Welcome to the addiction!!

I'm not as experienced as most of the folks on here, but I have been in your spot quite a few times and it is a difficult decision to make as you don't want to throw...
Forum: Reader's Ride's 03-20-2018, 08:00 PM
Replies: 1
Views: 887
Posted By BrokeGunner
Re: Brokegunner's 1971 800B Comanche rescue!!

So here are some better photos of it now that I have it partially cleaned up. Unfortunately there is more rust than what my mind remembers... but I guess it was true love and the old "eye of the...
Forum: Reader's Ride's 03-20-2018, 07:47 PM
Replies: 1
Views: 887
Posted By BrokeGunner
Cool Brokegunner's 1971 800B Comanche rescue!!

I finally have some time to sit down and create a post on my latest distraction; I found a real Comanche that was parked within 10 miles of my home for the past 20 years, and hasn't been registered...
Forum: Chit Chat 03-20-2018, 06:33 PM
Replies: 16
Views: 7,326
Posted By BrokeGunner
Re: Getting title in CA

I realize this is an old thread but for the sake of anyone interested, I've done 2 of these recently and both were successful.

On the first one I had no title but a BOS and a request for duplicate...
Forum: Basic Tech Questions 03-20-2018, 12:50 PM
Replies: 4
Views: 681
Posted By BrokeGunner
Re: Comanche sliding window rubber source?

I took some measurements of the channel and glass, as well as the remnants of rubber that are still in the channel. I also spent 2 hours looking at every single piece of rubber on Steele Rubber that...
Forum: Basic Tech Questions 03-16-2018, 11:23 AM
Replies: 4
Views: 681
Posted By BrokeGunner
Comanche sliding window rubber source?

I was able to find a replacement window for the rear sliding window on my Comanche (thanks!!) and now I am getting ready to install it in the Scout. It appears that I will need to remove the window...
Forum: Basic Tech Questions 01-21-2018, 08:32 AM
Replies: 1
Views: 482
Posted By BrokeGunner
1967 800 Front body mount question

I replaced the body mounts on my Orange/Vanilla Scout 800 but I did not do the front as I figured I needed to pull the radiator soon... now I am wondering if I screwed up!!!

Is it possible to...
Forum: Reader's Ride's 12-11-2017, 10:30 PM
Replies: 16
Views: 4,466
Posted By BrokeGunner
Re: Parked in a field for 30+ years, 68 Scout rescue and rehab

Not much progress on my scout lately, but I'm hoping to get some free time soon.

Yesterday I drove it around my property for 10 minutes and got the water temp up a little and then I removed the...
Forum: Reader's Ride's 12-11-2017, 09:01 AM
Replies: 9
Views: 8,657
Posted By BrokeGunner
Re: 1970 Scout 800A - "Grandpa's Scout"

That sure is a nice Scout!! I hope mine looks and runs that good... some day :)
Forum: Other IH Equipment 10-26-2017, 05:56 PM
Replies: 2
Views: 1,277
Posted By BrokeGunner
Re: IHC 3HP Stationary engine

I'm pretty sure it is original. It has a very old looking decal on it, and the paint has a nice faded patina, just like my scout!! ;)

It needs a fuel tank and a magneto, so I am guessing the...
Forum: Tool Talk 10-25-2017, 09:30 PM
Replies: 0
Views: 979
Posted By BrokeGunner
Cool Do all scout owners have an impact driver?

Seems like this should have been included from the factory on these old rust buckets!

I went to the big city the other day for a haircut and ended up at the pawn shop. They had a Snap-On impact...
Showing results 1 to 25 of 33

 

All times are GMT -8. The time now is 11:15 PM.