IH PARTS AMERICA
Click Here!

Go Back   IH PARTS AMERICA > Tech Forums > Transfer Case Tech
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read Photo Gallery IH Store Home

Reply
 
Thread Tools Display Modes
Old 04-19-2017, 08:58 AM   #1
Aubrey
Senior Member
 
Join Date: Jan 2010
Member Number: 1554
Location: Colorado
Posts: 154
Default Dana 20 Breather

Is the Dana 20 breather a press in or screw in? I have another tail that I just tapped the breather out of because it was round at the base, so I just figured it was pressed in. But now looking at it, it has grooves in it like it used to have threads prior to me tapping it out. Unless those are grooves just to hold it in.

I'm getting a lot of oil blowing out. I think it is the breather, but I'm not sure. I thought I'd try plugging something in and running a hose off it to see if that stops this oil slick I got going.
__________________
1974 Scout II, V-345A Gas 2-brl, Fed Exst Emiss Ctrl, Dual Horiz Tail Pipes, 3-Speed A727, D20, D44 3200# Locking Hub 11.75 Disc (elocker), D44 (Detroit, discs), 4.56, 19 Gal w/ Skid Plate, 105 amp 10SI, Saginaw Pwr Steer, Hvy Dty Rr Step Bumper, Dlx Ext Trim, Dlx Int Trim Blk
Aubrey is offline   Reply With Quote
Old 04-19-2017, 11:08 AM   #2
Scoutboy74
Moderator
 
Scoutboy74's Avatar
 
Join Date: Apr 2008
Member Number: 453
Location: Daze Crick, Jefferson
Posts: 3,571
Default Re: Dana 20 Breather

I can't answer your questions about the breather, but I do have some thoughts about the oil spewing. It is most likely the result of failed seals inside your adapter housing allowing atf to migrate into the t-case. Another sign of this is the occasional necessity to top off your trans fluid. Where's that fluid been going? Into your t-case. I'll bet if you pull your t-case fill plug, you'll have an absolute pressurized geyser of cross-mojinated atf and gear lube. I just dealt with this recently.
__________________
Favorite hobby...Driving Salma Hayek in my Scout

Coal Trickle - '99 Dodge Ram 2500 Q-Cab SWB 4x4 - 5.9L 24V CTD/NV4500
Hooty - '74 SII - 392/TF727/D20/3.73 D44's/Spartan FA/Krac-lok RA/RC 4" SUA/34x10.5 TSLs/33g Fuel/HFT 8k winch
Mongo - '71 1210 Std Cab 2WD - 345/TF727/RA17 D60 4.10 Trac-lok - "Mongo love candy! Duh, huh, huh!"
Scoutboy74 is offline   Reply With Quote
Old 04-19-2017, 11:52 AM   #3
1975IH200
Senior Member
 
1975IH200's Avatar
 
Join Date: Dec 2008
Member Number: 731
Location: 3rd to last cave on the right
Posts: 445
Default Re: Dana 20 Breather

The d-20 breather is pressed in. The grooves are normal, they assist in holding in the breather in place.

Threading in a 1/8" pipe thread where the breather is, then installing a hose fitting and hose works well, in my experience.

The trans-to-tcase adaptor has a drain hole in it which will allow any leakage to drain. If the hole is plugged, as can happen, then atf could get into the t-case.
Clear the drain hole and see if anything comes out.
The area inside the adaptor should not hold any fluid and is normally dry.
Attached Images
 
__________________

My Junk --> 1975 "200HD" AWD Truck
My Cave location --> Western North Carolina

Last edited by 1975IH200; 04-19-2017 at 12:58 PM..
1975IH200 is offline   Reply With Quote
Old 04-27-2017, 05:33 AM   #4
Aubrey
Senior Member
 
Join Date: Jan 2010
Member Number: 1554
Location: Colorado
Posts: 154
Default Re: Dana 20 Breather

The case is not over full. I can't even touch any oil through the fill hole. It's leaking, but not refilling.
__________________
1974 Scout II, V-345A Gas 2-brl, Fed Exst Emiss Ctrl, Dual Horiz Tail Pipes, 3-Speed A727, D20, D44 3200# Locking Hub 11.75 Disc (elocker), D44 (Detroit, discs), 4.56, 19 Gal w/ Skid Plate, 105 amp 10SI, Saginaw Pwr Steer, Hvy Dty Rr Step Bumper, Dlx Ext Trim, Dlx Int Trim Blk
Aubrey is offline   Reply With Quote
Old 04-27-2017, 05:04 PM   #5
Scoutboy74
Moderator
 
Scoutboy74's Avatar
 
Join Date: Apr 2008
Member Number: 453
Location: Daze Crick, Jefferson
Posts: 3,571
Default Re: Dana 20 Breather

That's good. I wasn't as lucky recently.
__________________
Favorite hobby...Driving Salma Hayek in my Scout

Coal Trickle - '99 Dodge Ram 2500 Q-Cab SWB 4x4 - 5.9L 24V CTD/NV4500
Hooty - '74 SII - 392/TF727/D20/3.73 D44's/Spartan FA/Krac-lok RA/RC 4" SUA/34x10.5 TSLs/33g Fuel/HFT 8k winch
Mongo - '71 1210 Std Cab 2WD - 345/TF727/RA17 D60 4.10 Trac-lok - "Mongo love candy! Duh, huh, huh!"
Scoutboy74 is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -8. The time now is 02:42 PM.